SunTouch SC50277105 (81011414) ProMelt Electric Snow and Ice Melt Cable, 277 VAC, 105 Square Ft.

Description

Application
ProMelt Cables are used to melt ice or snow from an exterior surface and are designed for outdoor use only embedded in concrete asphalt or sand
Minimum Bend Radius 1 inch
Maximum Exposure Temperature continuous and storage 221F 105C
Maximum Exposure Temperature shortterm for asphalt covering 285F 140C
Minimum Installation Temperature 40F 45C

Installation Paramaters
Determine a time to install the cable when equipment heavy tools and site traffic will be minimal
Apply the surfacing courses over the cable the same day the cable is installed
If installing cable in the upper layer of a twostage concrete slab or the upper layer of an asphalt application the cable should be completely ready for the second stage There is limited time between stages as the slab should not be allowed to fully cure or the asphalt to completely cool Therefore lay out the cable and tie it to rewire that can be quickly lifted into place after the first stage is laid
If a slab sensor is installed in this second layer plan ahead so this does not cause the first layer to cure or cool too much
Inspect the area and remove any sharp objects
Install in temperatures at least 40F 45C

For more information Click Here PDF

Please contact us for any additional options seen on specification sheet

SunTouch SC50277105 81011414 ProMelt Electric Snow and Ice Melt Cable 277 VAC 105 Square Ft